Node:Serial terminal, Next:Preset Menu, Previous:Network, Up:Top
This chapter describes how to use the serial terminal support in GRUB.
If you have many computers or computers with no display/keyboard, it would be very useful to control the computers with serial communications. To connect a computer with another via a serial line, you need to prepare a null-modem (cross) serial cable, and you may need to have multiport serial boards, if your computer doesn't have extra serial ports. In addition, a terminal emulator is also required, such as minicom. Refer to a manual of your operating system, for more information.
As for GRUB, the instruction to set up a serial terminal is quite
simple. First of all, make sure that you haven't specified the option
--disable-serial to the configure script when you built your
GRUB images. If you get them in binary form, probably they have serial
terminal support already.
Then, initialize your serial terminal after GRUB starts up. Here is an
grub> serial --unit=0 --speed=9600 grub> terminal serial
serial initializes the serial unit 0 with the
speed 9600bps. The serial unit 0 is usually called
COM1, so, if
you want to use COM2, you must specify
--unit=1 instead. This
command accepts many other options, so please refer to serial,
for more details.
terminal (see terminal) chooses which type of
terminal you want to use. In that case above, the terminal will be a
serial terminal, but you can also pass
console to the command,
terminal serial console. In this case, a terminal in which
you press any key will be selected as a GRUB terminal.
However, note that GRUB assumes that your terminal emulator is
compatible with VT100 by default. This is true for most terminal
emulators nowadays, but you should pass the option
the command, if your terminal emulator is not VT100-compatible or
implements few VT100 escape sequences. If you specify the option, then
GRUB provides you with an alternative menu interface, because the normal
menu requires several fancy features for your terminal.