[ < ] [ > ]   [ << ] [ Up ] [ >> ]         [Top] [Contents] [Index] [ ? ]

3.7 Redirecting Output

AutoGen provides a means for redirecting the template output to different files. It is accomplished by providing a set of Scheme functions named out-* (see section 3.4 AutoGen Scheme Functions).

`out-push (see section 3.4.27 `out-push-new' - purge and create output file)'
This allows you to logically "push" output files onto a stack.

`out-pop (see section 3.4.25 `out-pop' - close current output file)'
This function closes the current output file and resumes output to the next one in the stack.

`out-suspend (see section 3.4.29 `out-suspend' - suspend current output file)'
This function does not close the current output, but instead sets it aside for resumption with

`out-resume (see section 3.4.28 `out-resume' - resume current output file)'
This will put a named file descriptor back onto the top of stack so that it becomes the current output again.

`out-switch (see section 3.4.30 `out-switch' - close and create new output)'
This closes the current output and creates a new file, purging any preexisting one. This is a shortcut for "pop" followed by "push", but can also be done at the base level.

`out-move (see section 3.4.23 `out-move' - change name of output file)'
Renames the current output file without closing it.

There are also several functions for determining the output status. See section 3.4 AutoGen Scheme Functions.

This document was generated by Bruce Korb on February 17, 2003 using texi2html

Viewable With Any Browser   AutoGen Home